מחיר וייעוץ למוצר הזהדברו עם יועץ ובחרו את הפתרון שמתאים לכםפרטי המוצר מצורפים אוטומטית להודעת הוואטסאפ
עד 7 ימי עסקים בלבד
בהזמנות מעל 2000 ש״ח
הכוונה וייעוץ לפני רכישה
בהזמנות אונליין באתר
PLANET LS200-MF8 — חיישן משולב LoRaWAN. מאפשר לאסוף את נתוני המדידה של הדגם ולהעביר אותם באמצעות LoRaWAN למערכת תואמת. השימוש ברשת חיישנים מתאים לניטור נקודות מפוזרות במבנה או באתר, בלי להעביר כבל תקשורת לכל נקודת מדידה.
LoRaWAN Multi-Function Sensor. PLANET LS200-MF8 collects the measurements supported by this model and reports them over LoRaWAN to a compatible system. Wireless sensor networks can monitor distributed points in a building or site without a dedicated data cable to every measurement location.
PLANET LS200-MF8 · חיישנים ותקשורת IoT תעשייתית
PLANET LS200-MF8 מאפשר לאסוף את נתוני המדידה של הדגם ולהעביר אותם באמצעות LoRaWAN למערכת תואמת. השימוש ברשת חיישנים מתאים לניטור נקודות מפוזרות במבנה או באתר, בלי להעביר כבל תקשורת לכל נקודת מדידה.
2x 3.0V CR2450 button battery (Battery not included)
-10°C to 50°C
EU868: 863–870 MHz; US915: 902–928 MHz (regional configurations)
החיישן נבחר לפי סוג המדידה, טווח המדידה, רמת הדיוק ותנאי הסביבה. יש להתאים את תחום התדרים לשער ה־LoRaWAN ואת פענוח הנתונים ליישום. תדירות הדיווח ותנאי הקליטה משפיעים על העבודה השוטפת ועל צריכת האנרגיה.
טבלת המפרט באנגלית מרכזת את נתוני הדגם לצורך השוואה והתאמה טכנית. יש להתאים את ההזנה, החיבורים ותנאי הסביבה לערכים המפורטים. צוות סיבים מסייע בבחירת הציוד והתצורה המתאימים לפרויקט.
The PLANET LS200-MF8 collects the measurements supported by this model and reports them over LoRaWAN to a compatible system. Wireless sensor networks can monitor distributed points in a building or site without a dedicated data cable to every measurement location.
Choose the sensor for its measurement type, range, accuracy and environmental rating. Match the frequency band to the LoRaWAN gateway and the data decoder to the application. Reporting intervals and radio conditions affect operation and energy consumption.
The technical table below provides the model-specific information for comparison and system design. Match the power source, connectors and environmental conditions to these ratings. SIVIM can assist with equipment selection and configuration for the project.
| Specification | Details |
|---|---|
| Manufacturer / Model | PLANET LS200-MF8 |
| Technology | LoRaWAN |
| Frequency | EU868: 863–870 MHz; US915: 902–928 MHz (regional configurations) |
| TX Power | EU868: 16 dBm; US915: 20 dBm. Optional regional configurations: IN865 20 dBm; AS923 16 dBm; AU915 20 dBm; KR920 14 dBm. |
| Rx Sensitivity | -136dBm (LoRa, Spreading Factor = 12, Bitrate = 293bps) -121dBm (FSK, Frequency Deviation = 5kHz, Bitrate = 1.2kbps) |
| Work Mode | OTAA/ABP Class A |
| Power Supply | 2x 3.0V CR2450 button battery (Battery not included) |
| Operating Voltage | DC 2.3 ~ 3V |
| Battery Life Time | 2.26 years (25°C, 60-minute reports, TxPower=20dBm, SF10) |
| Dimensions (L x W x H) | 75.5 x 19.4 x 44 mm |
| Weight | 120 g |
| Sensor Dimensions | Reed Switch: 46 x 16 x 12.9mm Glass Break Sensor: 36 x 36 x 7.9mm |
| Ingress Protection | IP30 Reed switch – IP67 glass break – IP40 |
| Sensor Measurements | Temperature Sensor Information Measurement Range: -20°C to 55°C Measurement Accuracy: ±1°C Humidity Sensor Information Measurement Range: 0% RH to 100% RH Measurement Accuracy: ±7%RH Passive Infrared Sensor Information Detectable Angle: 80° horizontally / 55° vertically Detectable Range: 3m to 5m Light Sensor Information Illumination Measurement Range: 1 Lux to 3000 Lux Illumination Measurement Accuracy: <15% Tilt Sensor Information Conversion Angle: 45±5 degrees Contact Resistance: Less than 10 ohms The Insulation Resistance: Greater than 100 megohms Operating Temperature: -40°C to 85 °C Installation Type: Suitable for PCB at vertical state Vibration Sensor Information Model: Ball type omnidirectional signal trigger switch Voltage: <6V Current: 2uA to 10mA Insulation Resistance: >10M Ω Trigger Rate: 100% (amplitude > 1 mm, frequency > 20 Hz) Trigger Frequency: >50Hz Reed Switch Sensor Information Minimum Insulation Resistance 10^10 Ω Maximum Contact Resistance 100m Ω Maximum Switching Current 0.5A Glass Break Sensor Information Detection Mode: Piezoelectric buzzer Power Supply: Self-generated voltage chip Impedance: Normal (NC): 7Ω (max) Alarm (NO): 1MΩ (min) Sensor Sensing Range: within 2.5M radius Signal Sensing Time: 1-3 seconds Loop Voltage: 15VDC (max) Loop Current: 25mA (max) Operating Temperature: -10 to 50 °C Wire Length: 100cm |
| Operating Temperature | -10°C to 50°C |
| Relative Humidity | <90% RH (non-condensing) |
| Storage Temperature | -40 °C ~ 85 °C |
| Regulatory Compliance | CE RED, FCC PART 15B |
| Model | LS200-MF8 |
|---|---|
| Technology | LoRaWAN |
| Frequency | EU868: 863–870 MHz; US915: 902–928 MHz (regional configurations) |
| TX Power | EU868: 16 dBm; US915: 20 dBm. Optional regional configurations: IN865 20 dBm; AS923 16 dBm; AU915 20 dBm; KR920 14 dBm. |
| Rx Sensitivity | -136dBm (LoRa, Spreading Factor = 12, Bitrate = 293bps) -121dBm (FSK, Frequency Deviation = 5kHz, Bitrate = 1.2kbps) |
| Work Mode | OTAA/ABP Class A |
| Power Supply | 2x 3.0V CR2450 button battery (Battery not included) |
| Operating Voltage | DC 2.3 ~ 3V |
| Battery Life Time | 2.26 years (25°C, 60-minute reports, TxPower=20dBm, SF10) |
| Dimensions (L x W x H) | 75.5 x 19.4 x 44 mm |
| Weight | 120 g |
| Sensor Dimensions | Reed Switch: 46 x 16 x 12.9mm Glass Break Sensor: 36 x 36 x 7.9mm |
| Ingress Protection | IP30 Reed switch - IP67 glass break - IP40 |
| Sensor Measurements | Temperature Sensor Information Measurement Range: -20°C to 55°C Measurement Accuracy: ±1°C Humidity Sensor Information Measurement Range: 0% RH to 100% RH Measurement Accuracy: ±7%RH Passive Infrared Sensor Information Detectable Angle: 80° horizontally / 55° vertically Detectable Range: 3m to 5m Light Sensor Information Illumination Measurement Range: 1 Lux to 3000 Lux Illumination Measurement Accuracy: <15% Tilt Sensor Information Conversion Angle: 45±5 degrees Contact Resistance: Less than 10 ohms The Insulation Resistance: Greater than 100 megohms Operating Temperature: -40°C to 85 °C Installation Type: Suitable for PCB at vertical state Vibration Sensor Information Model: Ball type omnidirectional signal trigger switch Voltage: <6V Current: 2uA to 10mA Insulation Resistance: >10M Ω Trigger Rate: 100% (amplitude > 1 mm, frequency > 20 Hz) Trigger Frequency: >50Hz Reed Switch Sensor Information Minimum Insulation Resistance 10^10 Ω Maximum Contact Resistance 100m Ω Maximum Switching Current 0.5A Glass Break Sensor Information Detection Mode: Piezoelectric buzzer Power Supply: Self-generated voltage chip Impedance: Normal (NC): 7Ω (max) Alarm (NO): 1MΩ (min) Sensor Sensing Range: within 2.5M radius Signal Sensing Time: 1-3 seconds Loop Voltage: 15VDC (max) Loop Current: 25mA (max) Operating Temperature: -10 to 50 °C Wire Length: 100cm |
| Operating Temperature | -10°C to 50°C |
| Relative Humidity | <90% RH (non-condensing) |
| Storage Temperature | -40 °C ~ 85 °C |
| Regulatory Compliance | CE RED, FCC PART 15B |
© כל הזכויות שמורות לסיבים תשתיות תקשורת
פרסום בפייסבוק ע"י קרית טק
